For the painless detection of COVID-19 and
Influenza A/B infection and infectivity in
anterior nasal swab samples.
• Result in just 10 minutes!
• Outstanding Sensitivity: 100% at Ct≤30
97,9% at Ct≤32
• Specificity: 99.9%
1, Take out the extraction tube and the extraction tube cover, peel off the aluminum foil on the extraction buffer tube carefully and place the tube in the Tube Holder
2, Remove the swab from the container, being careful NOT to touch the soft end, which is the absorbent tip.
3, Gently insert the swab into one nostril for 2-4cm (1-2cm for children) until you feel a bit of resistance.
4,Using medium pressure, rub the swab slowly in a circular motion around the inside wall of your nostril 5 times within 7—10 seconds.
5, Repeat the same process with the same swab in the other nostril.
6, Insert the swab into the Extraction tube and immerse the entire tip of swab into the extraction reagent.
7, Soak the sampling swab below the liquid level of the extraction reagent. Rotate the swab and press for about 10 seconds. (Insert the swab into the extraction tube. Roll and press the swab head against the edge of the tube 3 to
5 times within the extraction reagent)
8, Squeeze the swab head against the inside of the extraction tube, then take out the swab and place the extraction tube cover firmly on the extraction tube. (Squeeze the extraction reagent from the swab tip as you remove the swab stick)
9, Open the aluminum foil pouch of the test cassette, place the test cassette on a flat surface.
10, Lay the cassette flat and add 2 drops of the treated sample into the sample well of the test cassette. Read the test result after adding the sample for 10 minutes. The result obtained after 30 minutes is invalid.
